Pool and Spa Controls

The Intermatic 119T340 is a 300 watt transformer. This model is designed to supply 12 volts to outdoor garden lights, submersible fixtures and spa or pool lights. It features the builtin circuit protection which disconnects the power in case of overload or defect. The Intermatic 119T340 offers you years of safe and efficient operation.

The Intermatic 119T86A is a 120 volt transformer. This model is designed for use with T8845PV sprinkler and irrigation time switch. It features a metal surge strip with 6 outlets.

This switch provides coordinated control for any pool/spa heater and any filter pump. It is designed to turn OFF a gas fired pool/spa heater approximately 20 minutes before the filter pump shuts down. This eliminates the problem of pounding and knocking due to overheated water, reduces scale and lime deposits and extends the service life of the heater.

The sensor is designed to protect the pool and spa equipment and plumbing against freeze damage. The sensor plugs into the circuit board on the back of the P1353ME and turns ON the filter pump when air temperature drops below the programmed temperature. The freeze programming mode will not appear unless the sensor is plugged into the clock.

Intermatic 178T24 THERMOSTAT FOR FP1102T/PF1103T

The Intermatic 21T156A is a pack of 4 standoff posts. These posts are designed for mounting wiring devices. With the help of Intermatic 21T156A, the toggle switches are mounted inside Intermatic control panels or pool/spa control centers.

Intermatic 21T166A - Spacer-Standoff - 3" long - 2 pack

List Price is for Whole Pack of 2 Pieces

These portable two-circuit fountain timers incorporate a plug in for a timed circuit (normally used for a pool pump) and a plug-in for a live circuit (typically used for a pool light). GFCI protected circuits and a three-prong grounded plug for the time switch supply are also built-in.

The Intermatic P1261P is a portable twocircuit fountain timer. This model includes a plugin for a pool pump (for a timed circuit) and a plugin for a pool light (for a live circuit). The timer also comes with a builtin threeprong grounded plug with GFCI protected circuits for the time switch supply.

The P1353ME mechanism can be installed into almost any Intermatic enclosure and has the ability to program up to three circuits. Choose between seven pre-programmed modes of operation, which include single speed pump or 2-speed pump/cleaner pump combinations. In addition, programmed modes that include auxiliaries can control pumps up to 3 HP as well as underwater, landscape and/or fountain lighting. Countdown and Override features allow cycle interruptions when pool/spa service is required. All timing and protection associated with filter pump/cleaner pump combinations and two-speed pumps has already been integrated into the software.

24Hr Programmable 1or2-Spd Seasonality Timer Mechanism with Additional Aux Circuit

Easily snap into most existing Inerratic enclosures with available mechanism support bracket - Controls up to three valve actuators - Switches heater and thermostat HIGH/LOW - Remote control capabilities - Mechanism only, type 3R enclosure not included

Used to control up to three valve actuators and two additional 120 VAC or 240 VAC loads - Can be used with the Intermatic PE650 - Can be used with the Intermatic PE953 - Automatic HIGH/LOW water temperature selector - Has connections for a hard wired or wireless remote and a master switch controller

Valve/Pump Switch Mechanism

Used in multiple applications: Filter pumps, Pool/Spa Lights, Water Features, Fountains - All plastic NEMA 3R rated for Indoor/Outdoor installation - Can be used with the Intermatic P1103FE Enclosure - 1.5 HP, 120 VAC; 3.0 HP, 240 VAC - Standard mechanism fits in all standard Intermatic time switch enclosures and swimming pool control panels

Replacement thermostat relay assembly for PF1202T & PF1222TB

Repair kit for all PAV series water valves (Includes Handle Retainer, cover screws, all o'rings)

The Intermatic PA114 black mounting bracket is especially designed for pools, spas, and pool-spa combinations. Versatile, rugged, and simple to install, this junction box safely supports the connections of up to four high or low voltage underwater lights. These mounting brackets are for use with the PJB4175 junction box and comply with all the requirements of UL1241 and the National Electric Code.

The Intermatic PA117 is a replacement latch kit. It is designed for Intermatic T10000R, T10004R, T10101R, T10404R, T10604R, and T12404R models.