Appliance

Refrigerator/freezer compressor start device and capacitor. The start device and capacitor provides a boost of power to the compressor during start-up. If the start capacitor is not working, the compressor may not start. - Fits Whirlpool® built refrigerators

The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed and the Overload provides added protection for the compressor. - Includes 2 overloads, a relay, a plastic cover box, 1 wire adapter, 2 start devices, and instructions - Fits Whirlpool® built refrigerators

Relay and Overload kit can replace 8201786, also used on Kenmore®, Whirlpool®, KitchenAid® and Roper® refrigerator, plus other brands manufactured by Whirlpool®. - Includes 2 overloads, a relay, a plastic cover box, 1 wire adapter, 2 start devices, and instructions

OLK Series Relay & Overload Kit can be used as a direct replacement on several Whirlpool®, Roper®, Estate®, KitchenAid®, Maytag® and Magic Chef® models. - Includes an overload, and a relay - Can be used with or without a run capacitor

All combinations are pre-wired. - Universal replacement on over 10,000 models as a universal relay overload kit - Fits Whirlpool® built refrigerators

Dryer power relay, used on Whirlpool® models. - Power relay supplies voltage to the heat and motor - Fits Whirlpool gas dryers

120V Water Valve with ⅜" and ½" adapter. Replaces most washer valves with side by side coils on a metal bracket. - Fits many older model machines

Solenoid valve for hot water - Fits Samsung® and Kenmore® Washers

Two solenoid valve for cold water - Fits Samsung® and Kenmore® Washers

Water inlet valve, can replace Samsung® models - Three solenoid valve for cold water

Washer water inlet valve, used on GE® models - Triple solenoid valve with connector

Washer water inlet valve, used on GE® models - Triple solenoid valve with connector

Single coil solenoid valve for hot water - Fits LG® front load washers

Four solenoid water inlet valve - Fits Samsung® front load washers

Washer inlet valve replaces Whirlpool® brands. - Two solenoid valve with 50 Ohm thermistor

Water fill valve 34001151 used on Sears®, Kenmore®, Maytag®, & Whirlpool® brand front loading, horizontal axis washing machines. - 2 Coil water valve for cold water

Used with some front load washers. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. - Two solenoid valve with 50 Ohm thermistor

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. - Dual solenoid valve with 50 Ohm thermistor

Washer water valve used on several GE® models - One double, one single valve on mounting bracket