Ballast / Transformer

Philips Advance Xitanium LED Driver, XI020C070V030RNP2, Maximum Output 20W 0.4-0.7A, 15-30Vdc, Input 120-277Vac, LE+TE Dimmable, 400mA to 700mA via DIP switches (refer to figure & notes in the Electrical Specification section)

Constant Current LED Driver, Type: LED-CU3536-CC-8W, I/P: 100-240Vac, 50/60Hz, O/P: 3-36Vdc, 350mA, Model: LD-CU3536AF, Pout: 1-8W, Short Circuit & Overload Protected

10 Watt LED Emergency Driver; 120-277 Volt

6W LED/CDL EM Driver, 90 Minute, 100-277V Input, LED Emergency Backup Driver, For use Satco 4/6/8/10 Inch Commercial Down Light

The ILB CP10 A from IOTA® is a UL Listed LED emergency driver that enables LED fixtures to deliver 90 minutes of emergency illumination during a loss of normal power. The ILB CP10 A is compatible with most Class 2 LED (10-60VDC) fixture designs and will automatically sense the required forward voltage needed to operate the LED in the emergency mode. The ILB CP10 A features dual flexible conduit for running wires to the normal AC driver and to the single-piece test switch/charge indicator accessory.

In the event of a power failure, the ILB CP05 switches to the emergency mode and operates the existing fixture for 90 minutes. The unit contains a battery, charger, and converter circuit in a single can and is available in different mounting configurations for individual fixture requirements. The ILB CP05 will operate an LED array load at 5 watts with constant power at a rated output voltage of 10V-60V.

In the event of a power failure, the ILB CP05 HE switches to the emergency mode and operates the existing fixture for 90 minutes. The unit contains a battery, charger, and converter circuit in a single enclosure and is available in different mounting configurations for individual fixture requirements. The ILB CP05 HE will operate an LED array load at 5 watts with constant power at a rated output voltage of 10V-60V. The ILB CP05 HE features high-efficiency performance and is certified in the CA Title 20 Appliance Efficiency Database.

Advance LED Electronic Driver, Input 120-277Vac, 50/60Hz, Output 40W, 0.1-1.1, 10-54Vdc, Class 2 0-10Vdc Dimming, SimpleSet, Power Factor>=0.9. Minimum Dimming 1%.

Independent direct current power supply. Triac dimmable, power output to 11W, Input 120V. This Driver Will Operate Following LED Models: Any module designed to accept 350mA, Constant current with voltage of 12-40V.