Ballast / Transformer

LED Driver with Selectable Output Current 250/300/350/400mA (Default 400mA) via Switches. 0-10V dimming to 5% with dim-to-off. Input Voltage 120-277Vac, Output Voltage 24V to 42V, Max. Output 16.8Watt.

Output Voltage 14V - 30V, Output Current 700mA, Max Output Power 20Watt, Class 2 Output, Universal input voltage 120 – 277 Vac, Side Lead Exit, Constant Current LED Driver

* This item has been discontinued. Please refer to the link below for the replacement we suggested

https://www.bulbspro.com/xi020c070v030rnp2.html

Output Voltage 2V - 42V, Output Current 35 - 350mA, Max Output Power 15Watt, Analog 0 to 10 vDC Voltage Control, Class 2 Output, Universal input voltage 120 – 277 Vac, Constant Current LED Driver

20W Single Output Switching Power Supply. Output Voltage 9V - 30V, Output Current 700mA, Class 2, Universal input voltage 100 – 240Vac, Side Lead Exit, Constant Current LED Driver

Output Voltage 5V - 17V, Output Current 700mA, Max Output Power 12Watt, Class 2 Output, Input Voltage 120 Vac, Trac Dimmable (Forward Phase Control), Side Lead Exit, Constant Current LED Driver, Dry & Damp Location Rated, Short Circuit and Open Circuit Protected

Independent direct current power supply. Triac dimmable, power output to 11W, Input 120V. This Driver Will Operate Following LED Models: Any module designed to accept 350mA, Constant current with voltage of 12-40V. 

Philips Advance Xitanium LED Driver, XI020C070V030RNP2, Maximum Output 20W 0.4-0.7A, 15-30Vdc, Input 120-277Vac, LE+TE Dimmable, 400mA to 700mA via DIP switches (refer to figure & notes in the Electrical Specification section)

The LED-TP10-BK is a 12 watt in-line driver for use with LED puck lights, LED strip and tape for undercabinet and cove lighting requirements.

White LED driver - runs up to 5 LED pucks from an in-line transformer (12W max.) by a wiring hub and/or with daisy chain

LED-DVR-DIM-12V-20W is a Class 2, constant voltage, 12V, 20W max. dimmable LED driver with power cord and a wiring hub; for use with 12V LED lighting products. Suitable for indoor use only.

Constant Voltage Design, 100-240VAC 0.35A 50/60Hz Input, 12VDC 1.0A Output, IP30 for Indoor LED Lighting, Class 2 LED Power Supply, Suitable for use in Dry and Damp Locations.

The LED-HWB12-WH is a 12 watt hardwire box for use with 12V DC LED puck lights, LED strip and tape for undercabinet and cove lighting requirements. The LED-HWB12-WH meets code for field hardwire installation.

Hard Wired LED Driver, Dimmable with any standard MLV TRIAC (Leading edge) dimmer switch, Nema 3R Enclosure – Outdoor Use, Two knock-outs one on each side, Class 2, ETL Listed, Certified to CSA Standard

Hard Wired LED Driver, Dimmable with any standard MLV TRIAC (Leading edge) dimmer switch, Nema 3R Enclosure – Outdoor Use, Two knock-outs one on each side, Class 2, ETL Listed, Certified to CSA Standard