Lovato BCG0524 - Automatic battery charger, switching BCG series, for sealed and not sealed lead-acid batteries, 1 charging level. 24VDC output, 5A

General characteristics

– Switching technology
– Wide auxiliary supply range
– High efficiency
– Two charging voltages selectable by DIP-switch
– Boost external control for full battery charging
– Hiccup function for battery recharging when its voltage is lower than 50% rated value
– Charging current limiting trimmer resistor
– Screw fixing or 35mm DIN rail mount (IEC/EN 60715).
Protection:
– Input fuse on AC side
– Electronic lock in case of short circuit on battery terminals, reverse battery polarity and output overload
– Automatic reset at end of alarm conditions.
LED indications:
– Power on
– Charging operation (I>30% Ic)
– Overload or short circuit conditions
– Reverse battery polarity.

Operational characteristics

– Auxiliary supply voltage:
110...240VAC ±10% 50/60Hz ±10%
– Charging voltage selectable by DIP-switch
• Non-sealed lead-acid batteries
• Sealed lead-acid batteries
– Maximum charging current can be set with a trimmer on the front: 20...100% of the rated current value
– Current limitation
– Charging cycle according to DIN 41773 standards
– IEC degree of protection: IP20.

Alarm output circuit

– Type of output: 5A 30VDC duty relay, normally energised.

Certifications and compliance

Certifications obtained: EAC; UL Recognized for USA and Canada (cURus - File E360865), as Power Supplies - Component.
Products having this type of marking are intended for use as components of complete workshop-assembled equipment.
Compliant with standards: IEC/EN 60950-1, IEC/EN 61000-6-2, IEC/EN 61000-6-4, UL 60950-1, CSA C22.2 n°60950-1.