Conduit & Fittings

The Intermatic RC127B is an air switch button and 75 ft. tubing for Gunite spas. This model is designed to allow control of pool pump, heater, air blower, or lights from the side of the pool with an air button without risk of electric shock. You can increase safety by controlling spa applications with the Intermatic RC127B. This model is also approved by CSA/CUS.

The Intermatic RC2163BFE is an air switch control system. This model is specifically designed to control spa/pool combinations reliably and economically away from the equipment. The system comes with two PE24VA 24Volt valve actuators. With one touch, the Intermatic RC2163BFE automatically turn ON the filter pump and override the 24Hour timer and switch the valves from poolfilter mode to the water/spa feature mode.

Tubing is run from the air button to the air control. When the air button is pushed a blast of air travels through the tubing and engages the air control.

Up to 44 ON/OFF settings per day Water metering increments from 12 minutes to 20 hours and 45 minutes 14-Day Skipper enables irrigation to be omitted on selected day(s) Provides for every other day operation ON/OFF/AUTOMATIC switch enables shutdown during rainy days and extended watering during dry periods without disturbing the cycle set on dial

Designed to supply 12 volts to pool/spa lights, submersible fixtures and outdoor garden lights - Grounded shield between the primary and secondary windings - Built-in circuit protection

The Intermatic 21T156A is a pack of 4 standoff posts. These posts are designed for mounting wiring devices. With the help of Intermatic 21T156A, the toggle switches are mounted inside Intermatic control panels or pool/spa control centers.

Water-resistant backlit display shows time of day, equipment status and water and air temperature - Programs and displays all on/off schedules, thermostat settings, time of day and variable pump speeds - Internal memory backup retains communication link during power outages - Ability to copy programming to additional remote controls - Uses three AA batteries (included)

Controls variable speed pumps and two-speed pumps - Included wireless transmitter allows you to control your pool or spa while relaxing in your backyard - Control 5 generic loads for single and two-speed filter pumps, cleaner pumps, pool lights, spa lights, landscape lights, fountains and water features - Enclosure for use as wiring compartment - For 120 or 240 Volt applications

Includes one P1353ME mechanism - Countdown and override features allow programs to be interrupted for service and automatically resumed without reprogramming your system - 48/1000-Inch steel with electrostatically applied light beige finish enclosure - 60-Amps, 120, 240 VAC or 120, 208 VAC single phase

Includes one P1353ME mechanism - Countdown and override features allow programs to be interrupted for service and automatically resumed without reprogramming your system - 48/1000-Inch steel with electrostatically applied light beige finish enclosure - 26-Inch (66.3 cm) Height by 18-Inch (45.9 cm) Width by 5-1/2-Inch (14.0 cm) Diameter - 125-Amps, 120, 240 VAC or 120, 208 VAC single phase

Controls up to 5 loads - 100 amp circuit breaker bus - 120VAC and 240 VAC capabilities - System displays status of each of the 4 on-demand circuits and pool/spa water temperature - Approved for direct connect of lights

Intermatic 21T166A - Spacer-Standoff - 3" long - 2 pack

List Price is for Whole Pack of 2 Pieces

The Intermatic PE30065RC is a 80 Amp, type 3R load center with the PE653RC MultiWave radio control for pool and spa control systems. This model contains all the necessary controls for the efficient, safe, and automatic operation of your pool and spa equipment in one panel. With this model it is easy to turn your digital control of PE series into a wireless control system. Get the Intermatic PE30065RC with included radio control and make it a fully operative system.

Includes one P1353ME mechanism;Countdown and override features allow programs to be interrupted for service and automatically resumed without reprogramming your system;48/1000-Inch steel with electrostatically applied light beige finish enclosure

Load center with four position 60 Amp breaker base. - Two knockouts for GFCIs and switches. - Controls 5 circuits. - Full thermostat control. - Operates single, two, and variable-speed pumps.

ONE EMPTY 16.5 X 10 X 4.75 IN. PE OUTDOOR ENCLOSURE WITH 60 AMP BUS

Includes P1353ME For a pool/spa combo Load center with four position 60 Amp breaker base Two knockouts for GFCIs and switches Controls 5 circuits Full thermostat control Operates single, two, and variable-speed pumps 24-hour scheduling capability for all connected equipment Type 3R indoor/outdoor 0.048" steel load center

PE Outdoor Enclosure with 80 Amp Bus

Can be used with Intermatic PE953, P1353ME, P4243ME, P4043ME - Used to control gas or electric heater thermostat - Parts can be added or replaced without interfering with the original system - Modules are capable of working within a system or independently - Receiver, antenna and instructions included