Conduit & Fittings

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. - Designed to fit specific Whirlpool® manufactured Washing Machine models - Water Inlet Solenoid Valve with Wire Harness. - Complete inlet valve & vacuum break assembly

Dual water inlet valve used on Bosch® washers

Washer water valve used on several Electrolux® models - 4 Coil Inlet valve

Hot water inlet used on Bosch® washers. - Single solenoid valve for hot water

Used with some front load washers. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. - Two solenoid valve with 50 Ohm thermistor

Washer water valve used on several GE® models - One double, one single valve on mounting bracket

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. - Dual solenoid valve with 50 Ohm thermistor

Tub to cabinet bungy strap - Fits newer GE® top load washers

Sits on top of transmission, under the tub

This door boot gasket replaces the damaged or leaky seal that prevents water from leaking out of your washer's front tub. - Washer Door Boot - .375" nozzle for window wash - Fits Samsung® & Kenmore® washers

This door boot gasket replaces the damaged or leaky seal that prevents water from leaking out of your washer's front tub.

Replaces both 279347 Lid Switch & 279782 Belt Switch - Includes 2 brackets, terminals & screws

Snap-in 3 Terminal Dryer Door Switch fits both older and newer models.

Direct Replacement Washer Lid Switch Assembly - Complete with both switches and 4 Amp fuse

3 Terminal Washer Lid Switch Assembly - Lid Switch - 24" wire leads with 14" plastic sleeve - Sleeve can be trimmed to length - Fits Whirlpool® direct drive washers

3 Round Terminals - 24" harness with round plugs and .875" block - Sleeve can be trimmed to length - Fits Whirlpool® direct drive washers

Lid switch assembly for direct drive washer. The lid switch assembly prevents the washer from spinning when the lid is open. If the lid switch assembly fails, the washer will not spin. - 11" harness with round plugs, .875" block - Fits Whirlpool® stack set

10 Amp, 1 / 2 HP, 125 / 250VAC - Used in the ES682 switch

3 Flat terminals - Harness plugs onto switch, top mount - Fits Whirlpool® direct drive washers