Electrical

Synchronous drive (no battery back up) - 21 Amp SPDT switch - Captive trippers with 15-minute intervals - 1/4-Inch quick-connect terminals - 3-way override

Synchronous drive (no battery backup) - 21 amp spdt switch - Captive trippers with 15-minute intervals - True clock face, easy-to-set - Clear plastic dust cover

Synchronous drive (no battery back up) - 21 Amp SPDT switch - Captive trippers with 15-minute intervals - 1/4-Inch quick-connect terminals - 3-way override

Synchronous drive (no battery back up) - 21 Amp SPDT switch - Captive trippers with 15-minute intervals - 1/4-Inch quick-connect terminals - No override

Beige finish - All plastic NEMA 3R rated for Indoor/Outdoor installation - Can be used with the Intermatic P1000 and P7000 Series - 93/8-Inch (23.9 cm) Height by51/2-Inch (14.0 cm) Width by 35/8-Inch (9.2 cm) Diameter - Combination 1/2-Inch - 3/4-Inch nominal knockouts, 1 on back and each side of enclosure, and 2 on bottom

The P1121 Heavy Duty Outdoor Timer is specifically designed to control outdoor decorations and holiday lighting, but it can also be used to the filter pump of an above ground pool. This 120-Volt timer has a manual override ON/OFF switch, a waterproof cover and a 12-Inch grounded cord.

To relocate the antenna and ensure communication between the Hand-Held and control center - Can be used with the Intermatic PE650 - Can be used with the Intermatic PE953 - Can be used with the Intermatic PA122 - Ensuring that communication between the Hand-Held unit and the control center is successful.

To relocate the antenna and ensure communication between the Hand-Held and control center - Can be used with the Intermatic PE650 - Can be used with the Intermatic PE953 - Can be used with the Intermatic PA122 - Ensuring that communication between the Hand-Held unit and the control center is successful.

Intermatic PA120 Timer DPST Relay w/ 24V AC Coil

The Intermatic PA117 is a replacement latch kit. It is designed for Intermatic T10000R, T10004R, T10101R, T10404R, T10604R, and T12404R models.

Repair kit for all PAV series water valves (Includes Handle Retainer, cover screws, all o'rings)

Replacement thermostat relay assembly for PF1202T & PF1222TB

Used in multiple applications: Filter pumps, Pool/Spa Lights, Water Features, Fountains - All plastic NEMA 3R rated for Indoor/Outdoor installation - Can be used with the Intermatic P1103FE Enclosure - 1.5 HP, 120 VAC; 3.0 HP, 240 VAC - Standard mechanism fits in all standard Intermatic time switch enclosures and swimming pool control panels

Valve/Pump Switch Mechanism

Used to control up to three valve actuators and two additional 120 VAC or 240 VAC loads - Can be used with the Intermatic PE650 - Can be used with the Intermatic PE953 - Automatic HIGH/LOW water temperature selector - Has connections for a hard wired or wireless remote and a master switch controller

Easily snap into most existing Inerratic enclosures with available mechanism support bracket - Controls up to three valve actuators - Switches heater and thermostat HIGH/LOW - Remote control capabilities - Mechanism only, type 3R enclosure not included

24Hr Programmable 1or2-Spd Seasonality Timer Mechanism with Additional Aux Circuit

The Intermatic P1261P is a portable twocircuit fountain timer. This model includes a plugin for a pool pump (for a timed circuit) and a plugin for a pool light (for a live circuit). The timer also comes with a builtin threeprong grounded plug with GFCI protected circuits for the time switch supply.

These portable two-circuit fountain timers incorporate a plug in for a timed circuit (normally used for a pool pump) and a plug-in for a live circuit (typically used for a pool light). GFCI protected circuits and a three-prong grounded plug for the time switch supply are also built-in.