Time Switches (Timer)

Single-gang Vertical with (WP17) Flexi-Guard Inserts, 2-1/4-Inch Depth, Gray - Complies with 2008 NEC Article 406.8(B) - Patented inserts offer more configurations and cover more jobs - Heavy-duty polycarbonate construction - Meets requirements for cold impact testing at -60 Degree Fahrenheit (-51 Degree Celsius)

The Intermatic WP1000HC is a singlegang, weatherproof receptacle cover. This horizontal cover is easy to install, as it already comes with base cover assembly, gasket, mounting screws and patented inserts. This clear receptacle cover is ideal for schools and commercial buildings. It is intended to be used for horizontal outdoor outlets which are situated in a wet location. This clear cover fits over any wall outlet or switch. The connection is protected from weather by its preadhered neoprene gasket. The cover provides usable inside depth of 2 1/4".

Single-gang Vertical with (WP17) Flexi-Guard Inserts, 2-1/4-Inch Depth, Gray - Complies with 2008 NEC Article 406.8(B) - Patented inserts offer more configurations and cover more jobs - Heavy-duty polycarbonate construction - Meets requirements for cold impact testing at -60 Degree Fahrenheit (-51 Degree Celsius)

This energy saving heavy-duty grounded timer plugs directly into the wall and controls 120-Volt air conditioners, heaters and any other heavy-electrical load up to 3 ON/3 OFF settings per day. Rated for loads up to 15 Amps resistive and 1750 Watts tungsten.

208-277 VAC; 40 Amps per pole - 3PST switch for control of 3-phase lighting - Three Skipper screws included - Independent clock motor terminals - This product should only be installed in Zone 34

208-277 VAC; 40 Amps per pole - 3PST switch for control of 3-phase lighting - Three Skipper screws included - Independent clock motor terminals - This product should only be installed in Zone 30

Load Center with T106M, T104M mechanisms Easy to wire Can house additional Intermatic mechanisms and components Heavy-duty Type 3R steel indoor/outdoor power center Applicable to filter pumps, blowers, low voltage pool/spa lighting, low voltage outdoor lighting.

Intended for disconnecting electrical equipment from its power source, quickly and safely, in case of emergency - Fits in a single-gang junction box and is rated for outdoor installations - Easy shut down procedure of the connected equipment by simply moving the large red lever to the OFF position - Electric grade plastic housing - Beige powder coated steel face plate

Used in multiple applications: Lights, Fans, Signs, Air Conditioners, Engine Block Heaters - 15-Amps (1800-Watt) Resistive or Tungsten; 1 HP Air Conditioner, (15 FLA, 90 LRA), Motor Load - Designed to control the filter pump of a portable pool or spa - Can also be used to turn ON and OFF outdoor decorations - Outdoor grade plastic enclosure

Noise Filter

Fits standard incandescent light sockets - Controls interior and exterior lights - 150 Watt maximum, incandescent only - Not for use with CFL or LED - Make sure photocell sensor is not illuminated by any artificial light sources

Beige finish - All plastic NEMA 3R rated for Indoor/Outdoor installation - Can be used with the Intermatic P1000 and P7000 Series - 93/8-Inch (23.9 cm) Height by51/2-Inch (14.0 cm) Width by 35/8-Inch (9.2 cm) Diameter - Combination 1/2-Inch - 3/4-Inch nominal knockouts, 1 on back and each side of enclosure, and 2 on bottom

The P1121 Heavy Duty Outdoor Timer is specifically designed to control outdoor decorations and holiday lighting, but it can also be used to the filter pump of an above ground pool. This 120-Volt timer has a manual override ON/OFF switch, a waterproof cover and a 12-Inch grounded cord.

To relocate the antenna and ensure communication between the Hand-Held and control center - Can be used with the Intermatic PE650 - Can be used with the Intermatic PE953 - Can be used with the Intermatic PA122 - Ensuring that communication between the Hand-Held unit and the control center is successful.

To relocate the antenna and ensure communication between the Hand-Held and control center - Can be used with the Intermatic PE650 - Can be used with the Intermatic PE953 - Can be used with the Intermatic PA122 - Ensuring that communication between the Hand-Held unit and the control center is successful.

Intermatic PA120 Timer DPST Relay w/ 24V AC Coil

The Intermatic PA117 is a replacement latch kit. It is designed for Intermatic T10000R, T10004R, T10101R, T10404R, T10604R, and T12404R models.

Repair kit for all PAV series water valves (Includes Handle Retainer, cover screws, all o'rings)

Replacement thermostat relay assembly for PF1202T & PF1222TB