Modular/DIN Rail Timers

This switch provides coordinated control for any pool/spa heater and any filter pump. It is designed to turn OFF a gas fired pool/spa heater approximately 20 minutes before the filter pump shuts down. This eliminates the problem of pounding and knocking due to overheated water, reduces scale and lime deposits and extends the service life of the heater.

The sensor is designed to protect the pool and spa equipment and plumbing against freeze damage. The sensor plugs into the circuit board on the back of the P1353ME and turns ON the filter pump when air temperature drops below the programmed temperature. The freeze programming mode will not appear unless the sensor is plugged into the clock.

Intermatic 178T24 THERMOSTAT FOR FP1102T/PF1103T

The Intermatic 21T156A is a pack of 4 standoff posts. These posts are designed for mounting wiring devices. With the help of Intermatic 21T156A, the toggle switches are mounted inside Intermatic control panels or pool/spa control centers.

Intermatic 21T166A - Spacer-Standoff - 3" long - 2 pack

List Price is for Whole Pack of 2 Pieces

Fits standard incandescent light sockets - Controls interior and exterior lights - 150 Watt maximum, incandescent only - Not for use with CFL or LED - Make sure photocell sensor is not illuminated by any artificial light sources

Noise Filter

Used in multiple applications: Lights, Fans, Signs, Air Conditioners, Engine Block Heaters - 15-Amps (1800-Watt) Resistive or Tungsten; 1 HP Air Conditioner, (15 FLA, 90 LRA), Motor Load - Designed to control the filter pump of a portable pool or spa - Can also be used to turn ON and OFF outdoor decorations - Outdoor grade plastic enclosure

Beige finish - All plastic NEMA 3R rated for Indoor/Outdoor installation - Can be used with the Intermatic P1000 and P7000 Series - 93/8-Inch (23.9 cm) Height by51/2-Inch (14.0 cm) Width by 35/8-Inch (9.2 cm) Diameter - Combination 1/2-Inch - 3/4-Inch nominal knockouts, 1 on back and each side of enclosure, and 2 on bottom

The P1121 Heavy Duty Outdoor Timer is specifically designed to control outdoor decorations and holiday lighting, but it can also be used to the filter pump of an above ground pool. This 120-Volt timer has a manual override ON/OFF switch, a waterproof cover and a 12-Inch grounded cord.

The P1131 portable outdoor pool timer is specially designed to control the filter pump of a portable or above-ground pool or spa, but it can also be used to turn on and off (in off-season) outdoor decoration, engine block heaters, and other appliances--indoors or outdoors. For applications up to 15 amps. Comes with twist-lock plug and receptacle.

These portable two-circuit fountain timers incorporate a plug in for a timed circuit (normally used for a pool pump) and a plug-in for a live circuit (typically used for a pool light). GFCI protected circuits and a three-prong grounded plug for the time switch supply are also built-in.

The Intermatic P1261P is a portable twocircuit fountain timer. This model includes a plugin for a pool pump (for a timed circuit) and a plugin for a pool light (for a live circuit). The timer also comes with a builtin threeprong grounded plug with GFCI protected circuits for the time switch supply.

24Hr Programmable 1or2-Spd Seasonality Timer Mechanism with Additional Aux Circuit

Easily snap into most existing Inerratic enclosures with available mechanism support bracket - Controls up to three valve actuators - Switches heater and thermostat HIGH/LOW - Remote control capabilities - Mechanism only, type 3R enclosure not included

Used to control up to three valve actuators and two additional 120 VAC or 240 VAC loads - Can be used with the Intermatic PE650 - Can be used with the Intermatic PE953 - Automatic HIGH/LOW water temperature selector - Has connections for a hard wired or wireless remote and a master switch controller

Valve/Pump Switch Mechanism

Used in multiple applications: Filter pumps, Pool/Spa Lights, Water Features, Fountains - All plastic NEMA 3R rated for Indoor/Outdoor installation - Can be used with the Intermatic P1103FE Enclosure - 1.5 HP, 120 VAC; 3.0 HP, 240 VAC - Standard mechanism fits in all standard Intermatic time switch enclosures and swimming pool control panels

Replacement thermostat relay assembly for PF1202T & PF1222TB