Modular/DIN Rail Timers

These portable two-circuit fountain timers incorporate a plug in for a timed circuit (normally used for a pool pump) and a plug-in for a live circuit (typically used for a pool light). GFCI protected circuits and a three-prong grounded plug for the time switch supply are also built-in.

The P1131 portable outdoor pool timer is specially designed to control the filter pump of a portable or above-ground pool or spa, but it can also be used to turn on and off (in off-season) outdoor decoration, engine block heaters, and other appliances--indoors or outdoors. For applications up to 15 amps. Comes with twist-lock plug and receptacle.

The P1121 Heavy Duty Outdoor Timer is specifically designed to control outdoor decorations and holiday lighting, but it can also be used to the filter pump of an above ground pool. This 120-Volt timer has a manual override ON/OFF switch, a waterproof cover and a 12-Inch grounded cord.

Beige finish - All plastic NEMA 3R rated for Indoor/Outdoor installation - Can be used with the Intermatic P1000 and P7000 Series - 93/8-Inch (23.9 cm) Height by51/2-Inch (14.0 cm) Width by 35/8-Inch (9.2 cm) Diameter - Combination 1/2-Inch - 3/4-Inch nominal knockouts, 1 on back and each side of enclosure, and 2 on bottom

Used in multiple applications: Lights, Fans, Signs, Air Conditioners, Engine Block Heaters - 15-Amps (1800-Watt) Resistive or Tungsten; 1 HP Air Conditioner, (15 FLA, 90 LRA), Motor Load - Designed to control the filter pump of a portable pool or spa - Can also be used to turn ON and OFF outdoor decorations - Outdoor grade plastic enclosure

Noise Filter

PE Outdoor Enclosure with 80 Amp Bus

Controls up to 5 loads - 100 amp circuit breaker bus - 120VAC and 240 VAC capabilities - System displays status of each of the 4 on-demand circuits and pool/spa water temperature - Approved for direct connect of lights

The Intermatic PE14065RC is a kit for pool use. It comes with an outdoor enclosure with dimensions of 14.75 x 14.75 x 4.25 inches. It comes with the PE653RC MultiWave ZWave wireless control system, a valve actuator control, and two compatible 24volt pool/spa water valve actuators.

The Intermatic valve actuator control is an affordable control that would only automate a set of water valves from the pool position to the spa position. It can turn a single water valve to engage a water feature. Easily snap into most existing Intermatic enclosures with available mechanism support bracket. Controls up to three valve actuators. Switches heater and thermostat HIGH/LOW and features remote control capabilities.

ONE P1403ME IN 9.375 X 5.5 X 3.625 IN. STEEL OUTDOOR ENCLOSURE

ONE EMPTY 14 3/4 X 14 3/4 X 4.25 IN. PE OUTDOOR ENCLOSURE

Includes one P1353ME mechanism;Countdown and override features allow programs to be interrupted for service and automatically resumed without reprogramming your system;48/1000-Inch steel with electrostatically applied light beige finish enclosure

The Intermatic PE30000T3 is a 80 Amp control system with a 300W transformer and type 3R load center for pool and spa control systems. This model contains all necessary controls for the efficient, safe, and automatic operation of your pool and spa equipment in one panel. With this model it is easy to turn your digital control of PE series into a wireless control system.

These heavy duty Time Switch Mechanisms are designed for industrial, commercial and residential applications, and have the highest motor load ratings in the industry. They provide up to 12 ONOFF operations each day with minimum ONOFF time of 1 hour. All models are equipped with ON and OFF trippers and can be installed in almost all Intermatic enclosures

The Intermatic PE30065RC is a 80 Amp, type 3R load center with the PE653RC MultiWave radio control for pool and spa control systems. This model contains all the necessary controls for the efficient, safe, and automatic operation of your pool and spa equipment in one panel. With this model it is easy to turn your digital control of PE series into a wireless control system. Get the Intermatic PE30065RC with included radio control and make it a fully operative system.

Controls a total of three timed circuits, including single speed or two-speed filter pumps, pool lights, spa lights and landscape lights;Countdown and override features allow programs to be interrupted for service and automatically resumed without reprogramming your system;48/1000-Inch steel with electrostatically applied light beige finish enclosure

Provide automatic control for pumps, cleaners and other types of loads - Quick connect terminals for easy installation - Timers have three-way mounting; flush in round opening, raised in rectangular opening or on base - Black housing with white screening and orange trippers - 8 oz (0.22 kg) All mechanisms are shipped in bulk (36 per carton) unless otherwise specified

Controls a total of three timed circuits, including single speed or two-speed filter pumps, pool lights, spa lights and landscape lights;Countdown and override features allow programs to be interrupted for service and automatically resumed without reprogramming your system;48/1000-Inch steel with electrostatically applied light beige finish enclosure