OUELLET OTR1502 - Floor Heating Cable for Membrane - 1500W - 120V - 1-phase

Series OTR

Floor Heating Cable for Membrane

The floor heating cable for membrane provides comfort and well-being through radiant heating.

• Produces enveloping heat that is also clean, cost-effective, uniform, and constant. 

• Specifically designed for use with uncoupling membrane installation systems.

• No mechanical fasteners required.

• Membrane provides mechanical protection for the cable.

Features

Voltage

• 120V, 240/208V, 1-phase.

Cold lead length

• 10’ (3 m).

Control

• Two types of control method possible (see instruction manual for details):

- Surface heating control with electronic thermostat in floor mode (F) and temperature sensor.

- Ambient heating control with electronic thermostat in ambient mode with floor limit (A or AF) and temperature sensor.

Note: A ground fault circuit interrupter (GFCI) must be used with this heating device unless exempted by the applicable national and/or local electrical code for the area of installation.

Included materials

• 15’ (4.6 m) temperature sensor.

• Measurements table label (to be placed in electrical panel).

Installation

• Never cut or shorten the heating cable.

• For indoor applications only.

• On concrete slab or plywood subfloor.

Warranty

• 25-year warranty on the heating cable.

Application

• Kitchen, bathroom, entrance way, family room, living room.

Construction

• Heating cable made of a twin conductor for a simpler and faster installation, compatible with uncoupling membrane systems.

Watt density

• 9.6W/sq. ft. (103W/sq. m), 3 3/4” (95 mm) spacing.
• 10W/sq. ft. (108W/sq. m), 3 1/2” (88 mm) spacing.
• 12W/sq. ft. (130W/sq. m), 3” (76 mm) spacing.

Installation

• On uncoupling membrane not included [3’’ (76 mm) minimal spacing].
• For heating cable installation on uncoupling membrane systems, consult the membrane manufacturer’s instructions to ensure that it is compatible with the use of heating cables.