OUELLET OWC-R2400 - Heating Cable for Concrete in Reel - 2400 Watts - 240/208 Volts - 1-Phase - 218.5 sq. ft. - 11W/sq. ft.

Features

Cold lead length
• 8’ 2’’ (2.5 m) cold lead included.

Control
• Two types of control method possible (see instruction manual
for details):
- Surface heating control with electronic thermostat in floor mode (F) and temperature sensor.
- Ambient heating control with electronic thermostat in ambient mode with floor limit (A or AF) and temperature sensor.
Note: A ground fault circuit interrupter (GFCI) must be used with this heating device unless exempted by the applicable national and/or local electrical code for the area of installation.

Included materials
• 15' (4.6 m) temperature sensor.
• Measurements table label (to be placed in electrical panel).

Installation
• Never cut or shorten the heating cable.
• For indoor applications only, residential or commercial.
• Installs under a 4" to 6" (10 cm to 15 cm) concrete slab or under a 1.5’’ to 4’’ concrete topping (4 cm to 10 cm).
Note: It’s highly recommended to insulate the concrete slab in order to avoid heat loss from below (see instruction manual for all installation details).
• Compatible with most floor coverings(check with the dealer or manufacturer).

Warranty
• 20-year warranty on the heating cable.

Application
• Basement, garage, bathroom, kitchen, family room, workshop, pool,shower, entrance way, hospital, hotel, factory, business, restaurant,sunroom, greenhouse, buildings used for housing animals.

Voltage
• 240/208V, 1-phase.

Construction
• Twin conductor heating cable with negligible magnetic field.

Watt density
• 11W/sq. ft. (120W/sq. m), recommended installation – 6’’ (15 cm) spacing.

Included materials
• Plastic tie-wraps (KIT-OW-TYW).

Installation
• Requires a metallic structure or wire mesh for reinforced concrete with spacing of 6'' (15 cm) for the installation.