Lithonia Lighting WF4 REG SWW5 90CRI MW M6 - 4" LED Regressed Switchable Baffle Downlight - 9W - 120V - 2700K/3000K/3500K/4000K/5000K - 650 Lumens - 90 CRI - Matte White Finish

HOUSING:
Die cast aluminum mounting frame with integral polycarbonate flange provides passive thermal cooling achieving L70 at 50,000 hours. Non-conductive dead-front trim design suitable for a wide range of applications and codes requiring a non-conductive • Lens regressed to .5" with baffle trim design to reduce glare for comfortable and even illumination • Non-conductive deadfront trim design suitable for a wide range of applications and codes requiring a non-conductive lens • FT4 3-pin plenum rated cable connector to connect from module to remote driver box • Steel spring clip for easy installation. 4" & 6" cut out templates are provided to ensure a correct sized hole is cut into ceiling for proper installation of the trim. Size of hole should not exceed 4 ¼ inches for the WF4 and 6 ¼ for the WF6 • Can be installed from 3/8” to 1 ½” ceiling thickness • Can be removed from below the ceiling for service or replacement.

LED LIGHT ENGINE:
LEDs are integrated to one piece high purity aluminum, thermally conductive housing to provide uninterrupted heat transfer to ensure long life of the LED Switchable white color temperature from 2700K, 3000K, 3500K, 4000K, 5000K • 90 CRI minimum • Color accuracy within 4 step McAdams Ellipse at the end CCT (2700K and 5000K), within 6 step McAdams Ellipse in the middle CCT (3000K, 3500K, and 4000K) • Dimming 100% to 10% with most standard incandescent dimmers (see list of approved dimmers).

DRIVER:
Connect directly to 120V Class-2 (CAN ICES-005 (B) / NMB-005 (B)) LED driver. 120V 60 Hz constant current driver provides noise free operation • IC rated driver with convenience of a switch to choose between 5 selectable color temperature options ranging from 2700K (warm white), 3000K, 3500K, 4000K, or 5000K (daylight) • The isolated driver integrated inside steel remote box with four 7/8" knockouts with slots for pryout. Suitable for pulling wires with the 12 cubic-inch wiring compartment to accommodate up to (6) 14 gauge insulated conductor or (4) 12 gauge insulated conductors; making the Wafer LED Downlights much easier to wire in 2in/2out (plus ground) daisy-chain applications and contractor friendly • 2" plenum space required for installation of the remote driver box • Suitable for installation in t-grid and drop
ceiling applications with universal new construction pan.

OPTICAL SYSTEM:
Edge-lit LED technology uses light guided plate to distribute light •Polycarbonate lens provides even illumination throughout the space • Efficient system that can produce over 650 lumens while using 9W with the WF4 and over 970 lumens while using 13W with the WF6 • Replaces 65W incandescent (WF4) and 75W incandescent (WF6).

LIFE:
Rated for 50,000 hours at 70% lumen maintenance.