Dryer Parts

Direct control of AC loads, such as dryer booster fans, in response to the current of a monitored AC circuit. 

FCS003 Automatically Turns on Booster Fan as soon as it Senses the Dryer Draws more than 1 Amp of Electric Current. 

The series FCS003 current switch was designed for monitoring AC. By sensing AC, this device controls AC load on motor, relay, lighting, fan, and applicably monitored circuit, together with contactor.

Designed by White-Rodgers® to replace the 'M' series dryer valves. -Contains direct replacement valve with 8 orifices (6 Natural Gas & 2 LP), 2 bushings & 2 nuts - 90° Left Outlet - Also replaces: 279888

Used in both washing machines, & dryers - Allows serpentine and extreme compact drive design - H Tooth Profile

This dryer fuse protects the dryer from damage by shutting off the voltage in the event of an electrical short. - Used on GE® dryers

30A Ceramic Fuse, 250V

List Price is for whole pack of 5 pieces

Direct replacement dryer heater element, can be used to replace Samsung® DC47-00019A - Includes coil, insulators, and mounting hardware

Dryer moisture sensor bar. If the dryer timer does not advance properly inspect the moisture sensor bars for damage which can cause the automatic drying cycle to not work properly.

Dryer lint screen for use on Samsung® models.

Dryer lint screen can replace W10120998 on Whirlpool®, Kenmore®, Maytag®, Roper®, KitchenAid® other brand gas and electric dryers. - Fits large capacity Whirlpool® built dryers

The Heating element works when a switch on the motor turns on the heating element, which heats the dryer. When the dryer reaches a pre-set temperature, the element is turns off. - Complete assembly with housing

Latch & Catch Assembly - Fits LG® & Kenmore® dryers

Replacement Dryer Blower Wheel can be used on LG® models - 7.625" Diameter - Accepts .50" shaft

Dryer lint filter with felt rim seal. - Can replace several LG® models - Improved wire mesh - Center support prevents tears

Dryer drum support roller. The rollers tend to wear at the same rate so both should be replaced while the dryer is apart. - Fits domestic and commercial machines - Fits Speed Queen®, and Amana®

Attaches to outer-most sides of bearing. - Polytetraflouroethylene

Replacement idler tension spring - Fits Samsung® and Kenmore® Dryers

Dryer idler pulley assembly. If the dryer drum does not turn check if the idler pulley is rotating freely and putting. - Fits domestic and commercial machines - Fits Alliance®, Speed Queen®, and Amana®

Complete tubular heating element includes 2 piece tube and coil. Fits many Maytag® models. A lower cost alternative to the factory part. - Complete assembly with housing